Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 211)

5-2
IM 04L31A01-01E
5.2 Program parameter setting > Pattern initial
setting
This section explains how to set basic items for setting program patterns. To carry out
the following procedure, you must set [Control] > [#1 Control action, Input setting] >
[Control mode] to a mode other than [Off] and [Program control] to [On]. For details on
the procedure, see section 4.1, “Control > Control action.” In addition, you must carry
out [Program initial setting] before you can set other [Program parameter setting] items.
Procedure
Opening the Setting Display
Press the keys in the following sequence:
MENU key (switch to the setting mode (control)) > #7 soft key (select [Program-
control parameters]) > #1 soft key (select [Program parameter setting]) > #1 soft key
(select [Pattern initial setting])
Note
• To carry out setup related to program control, you must press the DISP/ENTER key to
confirm the settings on the pattern initial setting display even if there are no changes.
• The [Segment edit mode] entry box appears only if you set [Segments] to a value other
than [0] and select a [Pattern number] that you have saved in the past. The [Edit segment
number] edit box appears when you set [Segment edit mode] to [Insert] or [Delete].
Setup Procedure
1. Use the arrow keys to move the cursor (blue) to the item box you wish to change.
A soft key menu is displayed at the bottom of the display.
2. Press the soft key corresponding to the value you wish to select.
The box for the item you changed turns yellow, and the cursor moves to the next
item.
3. Repeat steps 1 and 2 to change the value of all the items you wish to change.
4. Press the
DISP/ENTER key to confirm the changes.
The boxes for the items you changed turn from yellow to white, and the cursor
returns to the first item box.
5. Press the ESC key to return to the [Program parameter setting] menu.
To continue with program pattern setting, press the [#1] to [#6] soft keys to display
each setting display without carrying out step 6.