Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 241)

6-16
IM 04L31A01-01E
6.4 Operations on the Program Selection Display and Program Control Display (Only on Models with the
Program Control Option)
Displayed Information and Operations on the Program Control Display
([Set mode] > [#3 Trend/Save interval > Time/div] > [Time/div] setting)
Display of time per division
Switch tag/tag comment display
Show the program selection display
Switch full display/split display
Hold the program
Display the window for starting program control and resetting
Program
pattern name
display
Control pattern
number display
Control segment
number display
Remaining time display of
the control segment
Tag/Tag comment display
PV, SP, and OUT display
Control mode
display
Advance the program
Display the ON/OFF selection menu of program pattern display loops
Cursor indicating the
program execution position
Preset pattern
waveform
(dotted line)
PV waveform
(solid line)*
Soft key menu when in hold mode
Display the menu for selecting the loop of which
the target SP is to be changed
Display the window for changing the remaining segment time
Repeat segment range
* PV waveforms are
displayed when you
press the START
key to start the data
acquisition to the
internal memory.
Repeat frequency and repeat
count values
HOLD (blinking): Hold mode
WAIT:
Wait mode
DELAY: Program pattern
controlled being
delayed
Displays wait time when
in wait mode
Switch to control group display (style number S3 or later)
Switch to overview display (style number S3 or later)
Display the selection menu for the event display method
(style number S3 or later)
Turn the event display ON/OFF(style number S3 or later)
Soft key menu 2/2
Display soft key menu 2/2
Display soft key menu 1/2
Running and Resetting Program Control
1. Press the [RUN/RST] soft key .
A pop-up window for running and resetting the program control appears.
2. Select [RUN] or [RESET] using the up and down arrow keys .
3. Press the DISP/ENTER key to confirm the changes.
To close the window without making any changes, press the ESC key.
Advancing Segments
1. Press the [ADVANCE] soft key .
A pop-up window for advancing segments appears.
2. Press the DISP/ENTER key to execute the advance operation.
To cancel the operation, press the ESC key.