Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 173)

4-13
IM 04L31A01-01E
Control Function Related Setup Operations
4
4.4 Control > Relay
This section explains the procedures for setting the contact output for FAIL, self
diagnosis, and display hold.
Procedure
Opening the Setting Display
Press the keys in the following sequence:
MENU key (switch to Set mode) > Hold down the FUNC key for 3 seconds (switch
to basic setting mode) > #10 soft key (select [Control]) #4 soft key (select [Relay])
The following setting display appears.
Setup Procedure
1. Use the arrow keys to move the cursor (blue) to the item box you wish to change.
A soft key menu is displayed at the bottom of the display.
2. Press the soft key corresponding to the value you wish to select.
The box for the item you changed turns yellow, and the cursor moves to the next
item.
3. Repeat steps 1 and 2 to change the value of all the items you wish to change.
4. Press the
DISP/ENTER key to confirm the changes.
The boxes for the items you changed turn from yellow to white, and the cursor
returns to the first item box.
Saving the Settings
1. Press the ESC key .
The display returns to basic setting menu.
2. Press the [End] soft key .
A confirmation dialog box appears
3. Select [Yes] and press the DISP/ENTER key .
The operation screen is displayed.