Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 225)

5-16
IM 04L31A01-01E
5.11 AUX (Event Group) Settings (Style Number S3
or Later)
This section explains the setting procedure for event groups displayed in the program
selection screen and program operation display.
Procedure
Opening the Setting Display
Press the keys in the following sequence:
MENU key (switch to setting mode(control)) > #7 soft key (select [Program-control
parameters] > #4 soft key (select [AUX (Event group)]
The following display appears.
Setup Procedure
1. Use the arrow keys to move the cursor (blue) to the item box you wish to
change.
A soft key menu is displayed at the bottom of the display.
2. Press the soft key corresponding to the value you wish to select.
The box for the item you changed turns yellow, and the cursor moves to the next
item box.
3. Repeat steps 1 and 2 to change the value of all the items you wish to change.
4. Press the DISP/ENTER key to confirm the changes.
The boxes for the items you changed turn from yellow to white, and the cursor
returns to the first item box.
Setup Item
Event Display Groups
See section 5.6, “Program Parameter Setting > Event Setting” for information on event
settings.
• Pattern Number
Enter a group for each program pattern. You can display events registered to pattern
groups selected in the program selection screen.
• Detail
Select either time event or PV event.
• Number
Select numbers of events selected by type.