Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 219)

5-10
IM 04L31A01-01E
5.7 Program Pattern Settings > Hysteresis (PV
Event)
This section explains the PV event hysteresis setting procedure during program control.
Procedure
Opening the Setting Display
Press the keys in the following sequence:
MENU key (switch to setting mode(control)) > #7 soft key (select [Program-control
parameters] > #1 soft key (select [Program parameter setting]) > #6 soft key (select
[Hysteresis (PV event)])
The following display appears.
Setup Procedure
1. Use the arrow keys to move the cursor (blue) to the item box you wish to
change.
A soft key menu is displayed at the bottom of the display.
2. Press the soft key corresponding to the value you wish to select.
The box for the item you changed turns yellow, and the cursor moves to the next
item box.
3. Repeat steps 1 and 2 to change the value of all the items you wish to change.
4. Press the DISP/ENTER key to confirm the changes.
The boxes for the items you changed turn from yellow to white, and the cursor
returns to the first item box.
Setup Item
• PV event hysteresis (only on models with the program control option)
For each PV event 1-16, set the hysteresis in the range from 0.0 to 10.0%.