Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 224)

5-15
IM 04L31A01-01E
Program Control Related Setup Operations
5
Program display position
• Position
On the program selection display and program control display, the specified patterns
and PV waveforms can be displayed in the same display frame (full display) as well as
display data by dividing the display position per loop (split display). When using split
display, select the display position number from [1] to [6] for each loop. Applicable
loops are those set to [Control] > [#1 Control action, Input setting] > [Control mode] to
a mode other than [Off] and [Program control] to [On]. During cascade control, even-
numbered loops within the same terminal block are not displayed.
Full display example
Split display example (six divisions)
1
2
3
4
5
6
Display
position
number
Loop 1: 1
Loop 2: 2
Loop 3: 3
Loop 4: 4
Loop 5: 5
Loop 6: 6
Setting
Split display example (three divisions)
1
2
3
Display
position
number
Loop 1: 1
Loop 2: 2
Loop 3: 3
Loop 4: 1
Loop 5: 2
Loop 6: 3
Setting
• Operation Display Automatic Switching (Style Number S3 or Later)
When a program execution command is sent via the communication function, you can
have it switch to the program operation display.
ON: Switches to the program operation display when a program execution command
is sent.
OFF: Does not switch to the program operation display (default) even if a program
execution command is sent.
5.10 AUX (Auto message, Display position)