Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 275)

8-18
IM 04L31A01-01E
8.12 Measurement Function > Changing the Zone
Display of the Trend Display
This section explains how to specify the waveform display zone of each channel.
The measurement channel zone cannot be selected on 0 measurement channel models.
An error message will appear if the zone or graph setting screen is selected.
Procedure
Opening the Setting Display
Press the keys in the following sequence:
MENU key (switch to setting mode(control)) > MENU key (switch to Set mode) > #4
soft key (select [Display]) > #3 soft key (select [Zone,Graph]), #6 soft key (select
[Control (Zone,Graph)]), or #8 soft key (select [Math (Zone, Graph)])
The following display (if [Zone, Graph] was selected) appears.
If [Aux, Time Zone] > [Partial] is set to [Use], [Zone, Graph] in the menu appears as
[Zone, Graph, Partial], and the setting display shows the [Partial] entry box.
Setup Procedure
1. Use the arrow keys to move the cursor (blue) to the item box you wish to change.
The selections are displayed at the bottom section of the display.
2. Press the soft key corresponding to the value you wish to select.
The box for the item you changed turns yellow, and the cursor moves to the next item.
3. Repeat steps 1 and 2 to change the value of all the items you wish to change.
Note
The [Zone Lower/Upper] is set using the pop-up window that appears by pressing the [Input]
soft key.
4. Press the DISP/ENTER key to confirm the changes.
The boxes for the items you changed turn from yellow to white, and the cursor
returns to the first item box.