Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 175)

4-15
IM 04L31A01-01E
Control Function Related Setup Operations
4
4.5 Control > Tuning setting
This section explains the procedures for setting the parameters that are adjusted on the
tuning display.
Procedure
Opening the Setting Display
Press the keys in the following sequence:
MENU key (switch to Set mode) > Hold down the FUNC key for 3 seconds (switch to
basic setting mode) > #10 soft key (select [Control]) #5 soft key (select [Tuning setting])
The following setting display appears.
Setup Procedure
1. With the cursor (blue) located at the [Loop number] box, select the loop number for
setting the tuning parameter using the soft keys .
The selected loop number is displayed in the [Loop number] box, and the cursor
moves to the On/Off box of [01:].
2. Using the arrow keys , move the cursor to the On/Off box of the tuning parameter
you wish to change or the [Item name] box.
The box for the item you changed turns yellow, and the cursor moves to the next item.
Note
The [Item name] is set using the pop-up window that appears by pressing the [Detail] soft key.
On the pop-up window, set [Item ID] and [Item name]. Select [Item ID] using the soft key menu.
Enter [Item name] by pressing the [Input] soft key and using the character/number input keys.
3. Repeat steps 1 and 2 to change the value of all the items you wish to change.