Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 361)

14-13
IM 04L31A01-01E
Specifications
14
14.7 Options
Program Setup Function (/PG1 and /PG2)
Program Setup Function
Number of program patterns:
4(/PG1) and 30(/PG2)
Number of segments per program pattern:
Up to 99
Number of program segments:
Up to 300 (total of all program patterns)
Number of program events:
Up to 800
Program repeat count: Up to 999 or unlimited
Segment time: 0 min 1 s to 99 h 59 min 50 s
Program pattern start/stop:
Start, stop, hold, and advance the program pattern through
contact input or instrument operation
Program pattern switching:
Switch using contact input or instrument operation
Wait function: Wait time: Off, 0 min 1 s to 99 min 59 s
Wait zone: 0 to 100% of the measurement input span
PID Parameter Switching
Segment PID switching: Can specify the PID parameter number to be used for each
segment.
Zone PID switching: PID parameter switchable through the PV input value
Time Events
Output the progress status of the program pattern using contact output
Number of setpoints:
Up to 16 points per segment
Output: After a given time elapses after switching segments
Elapsed time: 0 to 99 h 59 min 59 s
PV Events
PV and deviation alarm function within the program pattern
Number of setpoints:
Up to 16 points.
Type: PV high limit, PV low limit, deviation high limit, deviation low
limit, deviation high/low limit, deviation high and low limits, SP
high limit, SP low limit, output high limit, and output low limit.
Control Mode Switching
Program RESET/Program RUN switching
Run/stop status of the program operation
HOLD/HOLD release: HOLD/release HOLD the progress of the program operation
when program is running