Quantum Data 881 - Manual (Page 98)

80 Chapter 2 Testing Video Displays
To run the ImageShift utility through the command line interface:
1. Establish a session with the generator using either HyperTerminal over a serial
connection or Telnet over an Ethernet LAN. See “ Configuring the generator’s serial
port ” on page 32 or “ Establishing a Telnet session with the generator ” on page 34.
2. Set the path to the imageshift files using the ISHP command. For example:
ISHP tffs0/library/imageshifts
3. Enter the following commands to display the list of imageshift files.
ISHQ? //Displays the first 5 imageshift filenames
ISHQ? //Displays 5 more imageshift filenames
4. Load an imageshift file and apply the image to hardware. For example:
ISHL Newshift //Loads the values from the imageshift file named
//Newshift
ISHG 1 //Initiates (gates on) the imageshift function
ISHU //Applies the values to the hardware
5. Apply the imageshift file to the hardware using the ISHU command. For example:
ISHU //applies the imageshift file to the hardware
To stop the ImageShift utility through the command line interface:
1. To stop the Imageshift enter the following command.
ISHG 0 //Stops (gates off) the imageshift function