Quantum Data 881 - Manual (Page 146)

128 Chapter 3 Administrative Tasks
Resetting a generator
You can reset a generator to a known good condition.
Note: Resetting does not restore the generator to factory default condition. Thus, it should
not be used to restore proper operation of the generator.
Follow this procedure to reset a generator.
To reset the generator using the command line interface:
1. Establish a session with the generator using either HyperTerminal over a serial
connection or Telnet over an Ethernet LAN. See “ Establishing a terminal session with
the generator ” on page 31 or “ Establishing a Telnet session with the generator ” on page
34.
2. Enter one of the following commands:
• To reset the generator, enter:
*RST
• To reset and calibrate the generator, enter:
*RST // Resets the generator
SCAL // Calibrates the generator