Quantum Data 881 User Manual
Page 639
881/882 Video Test Generator User Guide
(Rev A.22)
621
5. To run 2C-04 tests using the short read with the encryption enable pulse positioned at
the end of the vsync pulse, enter the following commands:
CPTX:CRIP 0
// Specifies short read.
CPTX:OESS 2
// Positions the pulse at end of vsync.
CPTX:CPTR 19
// Selects specific test (e.g. 2C_04).
CPTX:CPTU
// Initiates the execution of the test.
6. To run 2C-04 tests using the combined read with the encryption enable pulse
positioned at the beginning of the vsync pulse, enter the following commands:
CPTX:CRIP 1
// Specifies combined read.
CPTX:OESS 1
// Positions pulse at beginning of vsync.
CPTX:CPTR 19
// Selects specific test (e.g. 2C_04).
CPTX:CPTU
// Initiates the execution of the test.
7. To run 2C-04 tests using the combined read with the encryption enable pulse
positioned at the center of the vsync pulse, enter the following commands:
CPTX:CRIP 1
// Specifies combined read.
CPTX:OESS 3
// Positions pulse at center of vsync.
CPTX:CPTR 19
// Selects specific test (e.g. 2C_04).
CPTX:CPTU
// Initiates the execution of the test.
8. To run 2C-04 tests using the combined read with the encryption enable pulse
positioned at the end of the vsync pulse, enter the following commands:
CPTX:CRIP 1
// Specifies combined read.
CPTX:OESS 2
// Positions the pulse at end of vsync.
CPTX:CPTR 19
// Selects specific test (e.g. 2C_04).
CPTX:CPTU
// Initiates the execution of the test.
Refer to “
To view the HDCP compliance report:
” on page 651 for procedures on how to
view the generated report.