Quantum Data 881 - Manual (Page 663)

881/882 Video Test Generator User Guide (Rev A.22) 645
2. For the 882CA connect the cables as follows:
a. Connect an HDMI cable from the repeater device under test output to the 882
HDMI Rx 1 port.”
b. Connect an HDMI cable from the 882 HDMI Tx 1 port to the HDMI input of the
repeater device.
The following diagram depicts the test setup for the 882CA:
3. Activate the HDMI-H interface on the output port as follows:
c. Press the Interface key. A listing of signal interfaces appears on the generator’s
display as shown below.
d. Choose the HDMI-H item by pressing the adjacent soft key. The interface is
activated and the display is shown below.
Alternatively, to activate the interface through the command line interface, enter the
following commands:
XVSI 4 // Activates the HDMI-H interface
ALLU // Applies the interface setting to the generator
4. Press the Interface key repeatedly until the following menu appears:
HDMI/HDCP HDMI/HDCP
Source
882
Repeater
DUT
Sink
882
HDMI In HDMI Out
VGA
HDMI-D CVBS
S-VIDEO
SDI
*
HDMI-H
VGA
HDMI-D CVBS
S-VIDEO
SDI *HDMI-H
HDMI IN 1
HDMI IN 2 *