Grass Valley NV9000-SE v.5.0 - Manual (Page 518)

500
Misc. Configuration Pages
Hosts Table
• Log mode. This field is a drop-down list in which you can select one of 8 logging modes.
They are listed here, in order of the amount of information recorded:
No logging
Log errors
Log warnings
Log system events
Log transactions
Log all events
Log debugging info
Log verbose debugging info
(this consumes a great amount of disk space)
• Parameters.
You may ignore this field. It was created in an earlier version of NV9000-SE Utilities and is no
longer needed.
However, the field does accept one parameter: “ kr = off ” where “kr” means “kill rogues.”
“Rogues” are system components that are not responding to external stimuli. To “kill a
rogue” is to turn the software component off.
If the parameter field is “kr = off” exactly, the host does not kill rogues. If the parameter is
anything else, the host does kill rogues.
This parameter value might or might not have an effect on your system.
• Backup computer name.
You may ignore this field. It was created in an earlier version of NV9000-SE Utilities and is no
longer needed.
Buttons
At the bottom of the page are 5 buttons:
• Add
Click ‘Add’ to add a host to the table. NV9000-SE Utilities creates a new row at the bottom of
the router list in which you can enter host data.
(The ID is generated by NV9000-SE Utilities.)
• Delete
Select one or more rows in the ‘Hosts’ table and click ‘Delete’ to remove those hosts from the
table.
NV9000-SE Utilities deletes the hosts immediately and without warning.
• Save
Click ‘Save’ to commit (make permanent) the changes you have made in the page.
• Revert to Saved
Click ‘Revert to Saved’ to restore the saved version of the hosts table, discarding any changes
you have made (since the last save).
• ‘Save & Close’
Click ‘Save & Close’ to commit the changes you have made in the page and then close the
page.