Grass Valley NV9000-SE v.5.0 - Manual (Page 392)

374
Master Control
‘Add Nvision Master Control’ Page
With reference to outputs 91–93, audio over status is reported as follows:
Audio status and video status are reported using the same values as audio status and video
status in NP0019-00.
‘Add Nvision Master Control’ Page
The ‘Add Nvision Master Control’ page adds the master control subsystem you name as a new
router definition:
This page, as the start of a sequence, provides several fields that identify the basic properties of
a master control subsystem, i.e., an MCPM or MCE:
• Name
• Router Host
• Primary Control Point
At the bottom of the page are buttons that help you add master control subsystems:
• Add & Edit
• Add & Clear
• Clear
The buttons are grayed out (disabled) until you provide a name for the master control
subsystsem.
Value Meaning
Input = 0 The over was not selected
Input > 0 The over selection number