Grass Valley NV9000-SE v.5.0 - Manual (Page 408)

390
Salvos
‘Add Salvos’ Page
Buttons
At the bottom of the page are 4 buttons that allow you to move through the sequence of steps
in salvo definition:
• Previous
• Next
• Finish
• Cancel
The buttons are grayed out (disabled) until they become applicable. For instance, you cannot
use the ‘Previous’ button (to go to a previous page) until you have used the ‘Next’ button to go
to one of the next pages.
‘Previous’ Button
Click the ‘Previous’ button if you want to go to the previous page in the salvo definition
sequence.
‘Next’ Button
Click ‘Next’ to go to the salvo editing page. In this page, you specify the sequence of commands
in the salvo.
‘Finish’ Button
Click ‘Finish’ to accept the salvo thus far defined in the ‘Add Salvo’ page.
The salvo definition, as specified in the ‘Add Salvo’ page is incomplete. You must later go to the
salvo editing page to edit the salvo.
This button allows you to create a number of salvo definitions rapidly and complete them later.
After you click ‘Finish’, the ‘Add Salvo’ page remains and is re-initialized for additional entries.
‘Cancel’ Button
Click ‘Cancel’ if you want to terminate the salvo definition you started.
When you click ‘Cancel’, the ‘Add Salvo’ page re-initializes for another entry.
Basic Information
There are 2 fields in the basic information section:
These are the basic information fields:
• Mnenonic
Enter a name for the salvo in the ‘Mnemonic’ field. The name appears to operators on their
panels when they are selecting a salvo for execution.
• Description
Enter any description that is useful to your configuration.