Grass Valley NV9000-SE v.5.0 - Manual (Page 380)

362
Control Panels
EC9700
This is the ‘Salvos’ tab:
The page lists all salvos (locally defined salvos and system salvos).
To execute a salvo, click the salvo in the display and then click the ‘Take’ button. The ‘Take’
button remains grayed out until you select a salvo.
There are 6 buttons in addition to the ‘Take’ button. Most of these support the creation of locally
defined salvos (or “local salvos”):
• Start Recording
Click this button to start recording a local salvo.
 But first click one of the local salvos listed on the page. It is this salvo to which you will
record operations. The EC9700 configuration must have one or more local salvos defined
for you to be able to record to a salvo.
A local salvo is defined, by recording various panel operations, only for the panel at which it
is recorded. After you click the ‘Start Recording’ button, you then begin performing source
and destination selections, takes, and other operations in the sequence in which you want
them to be performed in the salvo.
• Pause Recording
Click this button to pause the recording of a local salvo.
If you have paused a salvo recording, any operations you perform are not included in the
salvo.
If you press the ‘Pause Recording’ button, it becomes a ‘Resume Recording’ button.
• Cancel Record
Click this button to cancel the recording of a local salvo.
Buttons
Salvo
List