Grass Valley NV9000-SE v.5.0 - Manual (Page 220)

202
Control Panels
Configuration Pages and Tables
LCD Selection Buttons
Selection buttons have many functions, not the least of which is to give feedback (e.g., source
and destination mnemonics) when the operator is performing takes.
The LCD selection buttons (of the NV640, etc.) do not necessarily correspond to any displayed
information.
When the panel is in XY mode, a set of selection buttons presents a set of virtual levels for the
selected destination device. If there are more levels than selection buttons, the ‘Page Up’ and
‘Page Down’ buttons activate and the operator can scroll through the level list.
When the panel is in MD mode, a set of selection buttons presents a set of MD devices. If there
are more destinations than selection buttons, the ‘Page Up’ and ‘Page Down’ buttons activate
and the operator can scroll through the destinations.
MD Destinations
Note that MD destinations are defined in panel configurations, not in the general configuration.
The setup of MD destinations is applicable on an individual panels basis.
Further, each MD destination has two options:
• ‘User Definable’
When an MD destination is “user definable, the operator may choose a different destination
using the panel buttons.
• ‘User Selectable’
When an MD destination is “user selectable,” the operator may select it and take sources to it.
Otherwise, the operator can see it but cannot use it.
You can also just to leave a destination out of the MD list if you do not want the operator to
use it.
Configuration Pages and Tables
These are the pages under the ‘Configuration’ pane for devices and categories:
• Control Panels Page • EC9700/EC9710 Page
These are the pages under the ‘Tasks’ pane:
• ‘Add Control Panel’ Page • ‘Add SW Panel’ Page
These are the tables under the ‘Views’ pane:
• Panels Table • GUIs Table
These pages and tables are described in the following sections.