Grass Valley NV9000-SE v.5.0 - Manual (Page 398)

380
External Interfaces
‘Add External Interface’ page
‘Add External Interface’ page
The ‘Add External Interface’ page starts a sequence of steps, in multiple pages, in which you
create a new external interface definition. There are two ways to get the ‘Add External Interface’
page:
• Click the ‘Add External Interface’ button at the bottom of the ‘External Interfaces’ page (of
the ‘Configuration’ pane).
• Click ‘Add External Interface’ in the ‘Tasks’ pane.
This is the ‘Add External Interface’ page:
This page, as the start of a sequence, provides several fields that identify the basic properties of
an external interface:
• Name
• Host
• Protocol
• Control Point
• Params
At the bottom of the page are buttons that allow you to move through the sequence of steps in
external interface definition:
• Previous
• Next
• Finish
• Cancel
The buttons are grayed out (disabled) until they become applicable. For instance, you cannot
use the ‘Previous’ button (to go to a previous page) until you have used the ‘Next’ button to go
to one of the next pages.