Grass Valley NV9000-SE v.5.0 - Manual (Page 256)

238
Control Panels
NV9605
Alphanumeric Display
The display has 3 fields of 8 characters:
• Status, labeled “S” on the panel.
The ‘Status’ field always shows the source that was routed to the currently selected destina-
tion, which is identified in the ‘Destination’ field.
• Destination, labeled “D” on the panel.
The ‘Destination’ field shows the current destination.
In multi-destination mode, the destination field shows the most recently selected destina-
tion and the status field changes to reflect the source most recently routed to that destina-
tion.
• Page, unlabeled.
The ‘Page’ field shows the current page (of four).
The ‘Status’ and ‘Destination’ fields can show either names belonging to a name set or the
system mnemonics.
Modes of Operation
The NV9605 operates in one of 2 modes:
• Limited X-Y Mode .
• Multi-Destination Mode .
The panel’s set of button functions varies slightly with the mode.
The modes (or behavioral models) are determined at configuration. The operator cannot switch
between different modes.
Limited X-Y Mode
In limited X-Y mode, takes occur from a single selectable source to a single selectable
destination.
If the panel has any level buttons, operators may perform breakaway — routing sources on
fewer than all levels.
Pressing a source button completes the take. There is no ‘Take’ button.
Multi-Destination Mode
In this mode, source buttons are configured with destinations as well as sources. Thus, each
source button completes a route to an individual destination.
There is no ‘Take’ button. Takes are all-level.