Grass Valley NV9000-SE v.5.0 - Manual (Page 110)

92
System Management
Navigation Pane
Delete Scope
If you want to delete a scope, click ‘Delete Scope’ in the ‘Configure DHCP’ dialog. A warning
appears:
Click ‘OK’ if accept these conditions. Click ‘Cancel’ if you do not.
 Be careful. This command should be issued rarely if ever and then only during the early
development of your systen. If you delete the scope, any panels on that scope will fail in their
attempt to restart.
Edit/View SNMP
The ‘Edit/View SNMP’ command presents an ‘SNMP Configution’ dialog:
Fig. 5-5: SNMP Configuration Dialog
The dialog has five parameter fields:
• Trap address
• Trap port
• Listening port
• ‘v2c Community’
• SNMP version
The dialog has two buttons:
• ‘Save Settings-Restart Services’
Click this button to save your changes to the SNMP settings and restart the SNMP service. (A
restart is required.)
 You should make the same changes to both system controllers if your system is a redun-
dant control system.