Grass Valley NV9000-SE v.5.0 - Manual (Page 336)

318
Control Panels
NV9649
On the left is a list of all destinations defined in the NV9000 system. On the right is a table of
the MD destinations you are defining. The number of rows in this table is equal to the maxi-
mum number of MD destinations your configuration allows.
To define an MD destination, select a destination on the left and copy it, using either the
‘Append’ button, the ‘Insert’ button, or the ‘Replace’ button, to the right.
The ‘Remove’ button removes highlighted MD destinations from the right.
At the bottom right, are ‘Move Up’ and ‘Move Down’ buttons. You can use these to adjust the
position in the list of any MD destination.
NV9649
NV9649 Panel Description
The NV9649 is a 2RU half-width control panel. Two NV9649s can be mounted in a rack side-by-
side with a rack mounting kit (part number NV9649-48-RMK). The panel has two sets of function
buttons and 4 displays:
At the rear are power, serial, and network connectors, and a 25-pin GPIO (tally) connector that
supports 4 optically isolated relay outputs and 8 optically isolated inputs:
The NV9649 has no virtual panel equivalant.
Behavioral Models
The NV9649 has 3 very different operating modes (or behavioral models):
Displays (4)
Knob Function Buttons (12) Function Buttons (16)
GPIO (tally)
Ethernet Serial (RS-232)
Power (2)