Metrohm viva 1.0 (process analysis) - Manual (Page 890)

8.4 Manual control - Functions
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
878 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
NOTE
We recommend masking the irrelevant output lines with an asterisk *
so as not to modify these line statuses.
[Set]
Sets the bit pattern defined under Output signal.
8.4.5 Sampler changer functions
8.4.5.1 Sample changer - Overview
Program part: Manual control
If a tower of a sample changer is selected in the subwindow for the device
selection, then the functions and parameters that are possible with this
sample changer are displayed in the subwindow for functions/parameters.
Sample changer functions
The sample changer functions are displayed on the following tabs:
￭ General
￭ Moving
￭ Assigning position
￭ Pump
Devices
The changer functions can be carried out with the following devices:
￭ 814 USB Sample Processor
￭ 815 USB Sample Processor
￭ 858 Professional Sample Processor
￭ 919 IC Autosampler plus
8.4.5.2 Sample changer - General
Program part: Manual control
Information on the attached rack is displayed here.
Rack name
Shows the name of the attached rack. If no rack is attached, -------- is dis-
played.
Rack code
Shows the rack code of the attached rack. If no rack is attached, -------- is
displayed.