Metrohm viva 1.0 (process analysis) - Manual (Page 613)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 601
Input range 0 - 6
Default value 1
Start base point
Number of decimal places for the start base point at which the peak eval-
uation baseline begins (V).
Input range 0 - 6
Default value 3
End base point
Number of decimal places for the end base point at which the peak evalu-
ation baseline ends (V).
Input range 0 - 6
Default value 3
Standardized area
Number of decimal places for the standardized peak area.
Only for the DT calibration method! This result is not calculated if the
measuring command is called by a CALL COND!
Input range 0 - 6
Default value 3
Standardized height
Number of decimal places for the standardized peak height.
Only for the DT calibration method! This result is not calculated if the
measuring command is called by a CALL COND!
Input range 0 - 6
Default value 3
Total volume
Number of decimal places and prefix selection for the current total volume
in the measuring vessel (L).
Input range 0 - 6
Default value 3
Selection # | m | µ | n | p
Default value #
Zero-order coefficient
Number of decimal places for the zero-order coefficient of the calibration
curve or standard addition curve.
Input range 0 - 6
Default value 3