Metrohm viva 1.0 (process analysis) User Manual
Page 38
2.3 Formula editor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
26
￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Designation
Description
Commands
HCR
Largest current measuring range used:
1 = 224 mA | 2 = 20 mA | 3 = 2 mA | 4 = 200 µA | 5 = 20 µA | 6 = 2 µA |
7 = 200 nA | 8 = 20 nA | 9 = 2 nA | 10= 200 pA
CVS
IME
Initial measured value (measured value before start conditions are processed) in
the unit of the measured value
CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
ITE
Initial temperature (temperature before start conditions are processed) in °C
CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
IVE
Value of the input at the end of the command
CONTROL
IVS
Value of the input at the start of the command
CONTROL
LCO
Loop counter = current number of completed runs, both of Repeat loops and
While loops
CALL COND,
CAL LOOP
Opt, LOOP
LCR
Lowest current measuring range used:
10= 200 pA | 9 = 2 nA | 8 = 20 nA | 7 = 200 nA | 6 = 2 µA | 5 = 20 µA |
4 = 200 µA | 3 = 2 mA | 2 = 20 mA | 2 = 224 mA
CVS
LP.CAx
Calculated value x (1 - 3) for the last measuring point on the measuring point list
MEAS Opt,
MEAS Opt
Conc
LP.CNT
Intensity of the last measuring point on the measuring point list in counts
CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc
LP.EXx
External value x (1 - 3) for the last measuring point on the measuring point list
MEAS Opt,
MEAS Opt
Conc
LP.MEA
Measured value for the last measuring point of the measuring point list in the unit
of the measured value
CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
LP.TEM
Temperature for the last measuring point of the measuring point list in °C
CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF