Metrohm viva 1.0 (process analysis) - Manual (Page 445)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 433
Identification Description
LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
LP.TRN Transmission of the last measuring point of the mea-
suring point list in %
MA.[MEA] Maximum measured value in the unit of the mea-
sured value
MA.CNT Intensity for maximum measured value in counts
MA.TEM 1) Temperature for minimum measured value in °C
MA.TIM Time for the minimum measured value in s
MA.TRN Transmission for maximum measured value in %
MI.[MEA] Minimum measured value in the unit of the measured
value
MI.CNT Intensity for minimum measured value in counts
MI.TEM 1) Temperature for minimum measured value in °C
MI.TIM Time for the minimum measured value in s
MI.TRN Transmission for minimum measured value in %
MTE Temperature measurement with sensor; (1 = on, 0 =
off)
2)
NMP Number of measuring points in measuring point list
STY Type of stop with which the command was stopped:
1 = normal; 0 = manual or after error
1) Command variable is invalid for the Avantes spectrometer
2) For the Avantes spectrometer, MTE always equals 0
5.5.2.5.4.2 MEAS Opt - General/Hardware
Tab: Method ▶ MEAS Opt ▶ Properties... ▶ MEAS Opt - 'Command name' ▶ Gen-
eral/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the instrument are defined on this tab.