Metrohm viva 1.0 (process analysis) - Manual (Page 406)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
394 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Entry 1 - 25 characters
Default value Series end track
Live display
on | off (Default value: on)
If this check box is activated, then the track will be displayed in the live
display.
Command variables
The following command variables are generated by the SERIES END
command in the method run and can be used in formulas under the des-
ignation 'Command name.Variable identification':
Identifi-
cation Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
5.5.2.2.7 EXIT
Dialog window: Method ▶ EXIT ▶ Properties... ▶ EXIT - 'Command name'
Start command for the exit track.
Appearance
The command has the following appearance:
Parameters
Command name
Name of the command.
Entry 1 - 25 characters
Default value Exit track
Live display
on | off (Default value: on)
If this check box is activated, then the track will be displayed in the live
display.