Metrohm viva 1.0 (process analysis) - Manual (Page 392)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
380 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
￭ CALL COND
Calling VA tracks for the conditioning of electrodes.
￭ CALL INTERCEPT
Calling VA tracks for calculating the intercept value.
￭ CALL VA
Calling VA tracks.
￭ CALL VMS
Calling VA tracks for calculating the VMS value.
￭ CAL Spec
Calibrating wavelengths.
￭ CTRL
Setting remote output lines.
￭ CVS
Electroplating bath analysis using CVS (Cyclic Voltammetric Stripping).
￭ EMPTY
Emptying a dosing unit.
￭ ERROR
Start command for the error track.
￭ EXIT
Start command for the exit track.
￭ HEATER
Controlling the heater.
￭ LIFT
Moving to a lift position.
￭ LOOP
Multiple execution of a command sequence.
￭ LQH
Extensive dosing possibilities with a Dosino.
￭ MEAS Opt
Measuring the absorbance.
￭ MEAS Opt Conc
Measuring the concentration (direct measurement).
￭ MEAS Ref
Measuring the reference spectrum.
￭ MEAS Spec
Measuring the sample spectrum.
￭ MEAS TMF
Determining the transmission factor.
￭ MOVE
Moving to a rack position or an external position.
￭ PREP
Preparing an exchange or dosing unit.
￭ PUMP
Switching the connected or built-in pumps on/off.
￭ RACK
Initializing the rack attached.