Metrohm viva 1.0 (process analysis) - Manual (Page 473)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 461
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
C0 Coefficient c0 of the calibration curve
C1 Coefficient c1 of the calibration curve
C2 Coefficient c2 of the calibration curve
C3 Coefficient c3 of the calibration curve
CAL Status of the calibration: 1 = calibrated normally,
0 = canceled, because reference wavelength was
not found
CP{#}.MEA Measured wavelength of the calibration point in nm.
If no measured peak can be assigned, then not
found will be entered
CP{#}.REF Reference wavelength of the calibration point in nm
DBL Total duration for the processing of the command in
s
FIN Command status: 1 = Command has been ended
at least once, 0 = Command was started but
not ended, invalid = Command was not started
(variable not available)
STY Type of stop with which the command was stopped:
1 = stopped normally, 0 = stopped manually
with [Quit] or [Stop]
TOL Tolerance within which a measured peak can be
assigned to a calibration wavelength
5.5.2.6.2.2 CAL Spec - General/Hardware
Tab: Method ▶ CAL Spec ▶ Properties... ▶ CAL Spec - 'Command name' ▶ Gen-
eral/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the instrument are defined on this tab.