Metrohm viva 1.0 (process analysis) - Manual (Page 182)

3.9 Curves subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
170 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Show spikes
Symbol
Selection of the symbol for the display of spikes.
Selection ● | ╳ | ✸ | ￭ | ▲ | no symbol
Default value no symbol
no symbol
Spikes are not shown.
Peak label
on | off (Default value: on)
If this check box is activated, then the substance name will be shown
above the corresponding family of curves (only once for the uppermost
curve). The substance name can only be displayed if it was possible to
allocate the peak to a substance from the substance table.
Orientation
Orientation of the peak label.
Input range 0 - 90 °
Default value 0 °
Line display
Options regarding the display of measurement curves and baselines. These
options apply to both smoothed and original curves.
Conditioning
Color of the measurement curve for conditioning.
Selection light gray | 13 colors
Default value light gray
Line thickness
Line thickness of the measurement curve for conditioning.
Input range 1 - 10 pixels
Default value 1 pixels
Intercept/VMS
Color of the measurement curve for intercept/VMS/electrolyte.
Selection dark gray | 13 colors
Default value dark gray