Metrohm viva 1.0 (process analysis) - Manual (Page 765)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 753
Time interval
on | off (Default value: off)
If this check box is activated, then the request to prepare the dosing
device is displayed after the time interval defined below.
all
Time interval after which the request to prepare the dosing device is dis-
played.
Input range 0.1 - 999.9 h
Default value 12 h
Connected devices
This is where information about the following peripheral devices connec-
ted to the MSB connector is displayed:
Dosing device 1
Dosing device type
Shows the dosing device type.
Dosing device serial number
Shows the serial number of the connected dosing device.
Stirrer 1
Stirrer type
Shows the stirrer type.
Stirrer serial number
Shows the serial number of the connected stirrer.
Remote Box 1
Shows the Remote Box connected.
7.1.4 Properties - Calibrator
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Calibrator
The general properties of the calibrator are displayed on the Calibrator
tab.
Calibrator serial number
Shows the serial number of the calibrator.