Metrohm viva 1.0 (process analysis) - Manual (Page 394)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
382 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
￭ SERIES END
Start command for series end track (see Chapter 5.5.1.2.5, page 375).
￭ EXIT
Start command for exit track (see Chapter 5.5.1.2.6, page 376).
￭ ERROR
Start command for error track (see Chapter 5.5.1.2.7, page 377).
5.5.2.2.2 START
5.5.2.2.2.1 START - Overview
Dialog window: Method ▶ START ▶ Properties... ▶ START - 'Command name'
Start command for the main track.
Appearance
The command has the following appearance:
Parameters
The parameters for the START command are set on the following three
tabs:
￭ General
General settings for the method run.
￭ Application note
Possibility of creating an application note to be displayed at the start of
the determination.
￭ Sample data variables
Specification of sample data variables that are to be available for the
method.
Command variables
No command variables are generated in the method run by the START
command.
Sample data variables
The following sample data variables are defined in the START command
and can be used in formulas under the designation 'SD.Variable
name.Variable identification':
Identification Description
VAL Variable value (optional, i.e. 'SD.Factor'
= 'SD.Factor.VAL') (Text, Number or
Date/Time)