Metrohm viva 1.0 (process analysis) - Manual (Page 174)

3.9 Curves subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
162 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Display
on | off (Default value: on)
Indicates whether a measurement curve is displayed in the curve window
or not.
Buttons
Save
The settings concerning the display of individual curves and the height
ratio between curve window and table are saved with this button.
Selection on
The marking of the curves selected in the table is activated with this but-
ton.
Selection off
The marking of the curves selected in the table is deactivated with this
button.
3.9.2 Curve properties
3.9.2.1 Curve properties - General parameters
Dialog window: Database / Workplace ▶ Curves # ▶ Properties Curves #
Command type
Selection of the command type for which the curve properties are to be
defined. The curve properties defined for each command type are saved
per curve window and per client.
Selection CVS | MEAS Ref | MEAS Spec | MEAS Opt | CAL
Spec | MEAS TMF
Default value CVS
NOTE
When the dialog window is opened, the Command type that applies
for the curve shown in the curve window will be selected by default.