Metrohm viva 1.0 (process analysis) - Manual (Page 410)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
398 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
1 Stirrer on
The stirrer is switched on with the defined Stirring rate.
2 Stirring time
Idle until the period defined in the Stirring time parameter has
expired.
3 Potential 1
Potential 1 is applied to the electrodes.
4 Waiting time 1
Idle until the period defined in the Waiting time 1 parameter has
expired.
5 Potential 2
Potential 2 is applied to the electrodes.
6 Waiting time 2
Idle until the period defined in the Waiting time 2 parameter has
expired.
7 Potential 3
Potential 3 is applied to the electrodes.
8 Waiting time 3
Idle until the period defined in the Waiting time 3 parameter has
expired.
only for hydrody-
namic measurement
= off
9 Stirrer off
The stirrer is switched off.
10 Start potential
The Start potential defined in the sweep is applied to the elec-
trodes.
11 Equilibration time
Idle until the period defined in the Equilibration time parameter
has expired.