Metrohm viva 1.0 (process analysis) - Manual (Page 482)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
470 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Displayed only when Device type = 089 Photometer.
Selection continuous | off
Default value continuous
continuous
A temperature sensor must be connected. The temperature will then
be measured continuously.
off
The temperature will not be measured. The temperature entered man-
ually under Temperature on the Measuring parameters tab will be
used.
Stirrer
This section is displayed only when Device type = 089 Photometer.
Stirrer
Selection of the stirrer.
Selection 1 | off
Default value 1
off
Means that no stirrer will be used.
Stirring rate
Setting the stirring rate.
Input range 0 - 15
Default value 3
Switch off automatically
on | off (Default value: on)
If this check box is activated, the stirrer will be switched off automatically
when the command has finished.
5.5.2.6.4.3 CAL MEAS Opt - Measuring parameters
Tab: Method ▶ CAL MEAS Opt ▶ Properties... ▶ CAL MEAS Opt - 'Command
name' ▶ Measuring parameters
Command name
Name of the command.
Entry 25 characters
The measuring parameters for the calibration are defined on this tab.