Metrohm viva 1.0 (process analysis) - Manual (Page 329)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 317
4.6.2.2.3 Curve properties CVS - y2 axis
Tab: Workplace / Database ▶ Curves # ▶ Properties Curves # ▶ y2 Axis
Parameters for the graphical display of the overlaid curves on the y2 axis
(right-hand y axis).
Quantity
Selection of the quantity to be shown on the y2 axis.
Selection Current [A] | Voltage [V] | Time [s] | Current
measuring range [A] | off
Default value off
Label
Freely definable axis label for the y2 axis. If auto is selected, then the des-
ignation from the Quantity field will be used.
Selection 50 characters | auto
Default value auto
Numerical format
Selection of the numerical format for the labeling of the y2 axis.
Selection decimal | scientific | engineering
Default value engineering
decimal
The axis is labeled in the decimal format ±##.### (floating-point num-
ber).
scientific
The axis is labeled in the scientific format ±#.###e±###.
engineering
The axis is labeled in the technical format ±###.###+prefix (engi-
neering format). The prefix (m, µ, n, p) is added to the figure.
Manual scaling
on | off (Default value: off)
If this check box is activated, then the y2 axis can be manually scaled in
the curve window. In this case, the Start value and End value fields can
be edited. If this check box is not activated, then the y2 axis will be auto-
matically scaled.
Start value
Initial value for scaling the y2 axis.