Metrohm viva 1.0 (process analysis) - Manual (Page 502)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
490 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
846, 894
Selection 1 | 2 | 3 | 4
Default value 1
814, 815, 858, 919
Selection
1 | 2 | 3
Default value 1
089
Selection
1
Default value 1
Name of dosing unit
Selection of a dosing unit from the dosing units available in the table of
the dosing units.
Selection 'Name of the dosing unit' | not defined
Default value not defined
'Name of the dosing unit'
Alphabetically organized selection of the names of the dosing units
from the table of dosing units in the configuration. A check is made
prior to the start of a method to determine whether the selected dos-
ing unit is identical with the name of the dosing unit at the selected
MSB connector.
not defined
No check is made prior to the start of a method to determine whether
the selected dosing unit is identical with the name of the dosing unit at
the selected MSB connector. This has the advantage that a method can
be utilized by users who use other dosing units.
5.5.2.7.6.3 LQH - Parameters
Tab: Method ▶ LQH ▶ Properties... ▶ Parameters
Command name
Name of the command.
Entry 25 characters
The Liquid Handling function is defined on this tab.
Function
Selection of the Liquid Handling function that is to be carried out.