Metrohm viva 1.0 (process analysis) - Manual (Page 882)

8.4 Manual control - Functions
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
870 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
8.4.2 Dosing
8.4.2.1 Dosing - Overview
Program part: Manual control
If the Dosing devices group or a single Dosing devices is selected in
the subwindow for device selection, then the functions and parameters
that are possible with these dosing devices are displayed in the sub-
window for functions and parameters.
Dosing functions
The dosing functions for dosing units are displayed on the following tabs:
￭ General
￭ Preparing
￭ Filling
￭ Emptying
￭ Fixed volume
￭ Dosing
Devices
The dosing functions can be carried out with dosing devices that are built
in or connected to the following instruments:
Voltammetry instrument: 894
Dosing device: 800
Dosing Interface: 846
Sample changer: 814, 815, 858, 919
Photometer: 089
8.4.2.2 Dosing - General
Program part: Manual control
Information on the dosing device selected, the attached dosing unit and
the solution contained therein is displayed here. This tab only appears if a
single dosing device is selected.
Dosing unit
Name
Shows the designation for the dosing unit entered in the configuration.
Cylinder volume
Shows the cylinder volume of the dosing unit.