Metrohm viva 1.0 (process analysis) - Manual (Page 583)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 571
5.5.2.11.7 STEPPING MOTOR
5.5.2.11.7.1 STEPPING MOTOR - Overview
Dialog window: Method ▶ STEPPING MOTOR ▶ Properties... ▶ STEPPING MOTOR
- 'Command name'
Instruments
This command can be executed with the Stepping Motor Controller.
Appearance
The command has the following appearance:
Mode of operation
Time-controlled actuation can be used with stepping motors.
Parameters
The parameters for the STEPPING MOTOR command are set on the fol-
lowing tabs:
￭ General
￭ Stepping motors
Command variables
The following command variables are generated by the STEPPING
MOTOR command in the method run and can be used in formulas under
the designation 'Command name.Port name.Variable identifica-
tion':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
5.5.2.11.7.2 STEPPING MOTOR - General
Tab: Method ▶ STEPPING MOTOR ▶ Properties... ▶ STEPPING MOTOR - 'Com-
mand name' ▶ General
Command name
Name of the command.