Metrohm viva 1.0 (process analysis) - Manual (Page 582)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
570 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Selection 'Controller name' | not defined
Default value not defined
Controller type
Shows the type of the selected controller output.
Selection Direct controller | Two-point controller | PID
controller | PWM controller
Setpoint value
Setpoint value to which the control is to be set.
This parameter is not displayed when Controller type = Direct control-
ler.
Input range -214783647.000 - 214783647.000 'Mapping
unit of the analog input or of the calculated
value'
Default value 'empty' or default value from the selected
controller 'Mapping unit of the analog input
or of the calculated value'
Control variable
Shows the designation of the analog input port or of the calculated value
(formula entry).
This parameter is not displayed when Controller type = Direct control-
ler.
Action
Selection of the controller action.
Selection Switch on | Switch off | Duration
Default value Switch on
Switch on
Activation of the regulation.
Switch off
Deactivation of the regulation.
Duration
Activation of the regulation during a defined period.
Duration
Time period during which controlling is to take place.
Input range 0.0 - 9,999.9
Default value 10.0
Selection min | s
Default value s