Metrohm viva 1.0 (process analysis) - Manual (Page 488)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
476 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Identification Description
VOL Currently dosed volume in L (Number)
5.5.2.7.2.2 ADD AUX - Properties
Dialog window: Method ▶ ADD AUX ▶ Properties... ▶ ADD AUX - 'Command
name'
Command name
Name of the command.
Entry 25 characters
Auxiliary solution
Solution
Entry of a solution name, selection of an auxiliary solution from the solu-
tion table or selection of a standard solution from the method or from the
solution table. The selection of a solution from the solution table is neces-
sary only if the solution is to be added automatically with a dosing device
or if the working life of the solution is to be checked at the start of the
method.
Entry 1 - 25 characters
Selection 'Solution name' | 'empty'
Default value 'empty'
'Solution name'
The auxiliary solutions defined in the solution table (Configuration)
appear first for selection, followed by the standard solutions defined in
the method, and then the standard solutions present in the solution
table (Configuration) (each time in alphabetical order).
Volume
Volume of the auxiliary solution that is to be dosed in.
Input range 0.010 - 1,000.000 mL (Increment: 0.001)
Default value 5.000 mL
Include volume in calculation
on | off (Default value: on)
If this check box is activated, then the volume added is allocated in the
volume bookkeeping.
Addition
Selection of the addition mode for dosing auxiliary solutions.