Metrohm viva 1.0 (process analysis) - Manual (Page 290)

4.5 Determination overview
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
278 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Editable only when autoscaling is deactivated.
Input range
-1.00E+12 - +1.00E+12
Default value -1.00E+12
End value
End value for scaling the x axis.
Editable only when autoscaling is deactivated.
Input range
-1.00E+12 - +1.00E+12
Default value +1.00E+12
Curve properties CVS - y1 axis
Tab: Workplace / Database ▶ Curves # ▶ Properties Curves # ▶ y1 Axis
Parameters for the graphical display of the curves on the y1 axis (left-hand
y axis).
Quantity
Selection of the quantity to be shown on the y1 axis.
Selection Current [A] | Voltage [V] | Time [s] | Current
measuring range [A]
Default value Current [A]
Label
Freely definable axis label for the y1 axis. If auto is selected, then the des-
ignation from the Quantity field will be used.
Selection 50 characters | auto
Default value auto
Numerical format
Selection of the numerical format for the labeling of the y1 axis.
Selection decimal | scientific | engineering
Default value engineering
decimal
The axis is labeled in the decimal format ±##.### (floating-point num-
ber).
scientific
The axis is labeled in the scientific format ±#.###e±###.
engineering
The axis is labeled in the technical format ±###.###+prefix (engi-
neering format). The prefix (m, µ, n, p) is added to the figure.