Metrohm viva 1.0 (process analysis) - Manual (Page 588)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
576 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
EPP Port position after exiting the command: 0 = invalid
position
FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
5.5.2.11.8.2 PORT - Properties
Dialog window: Method ▶ PORT ▶ Properties... ▶ PORT - 'Command name'
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Shows the instrument type.
Selection 846 Dosing Interface
Default value 846 Dosing Interface
Multiport valve
Multiport valve
Select the MSB connector the multi-port-valve is connected to.
Selection 1 | 2 | 3 | 4
Default value 1
Port
Selection of the target port to be switched to.