Metrohm viva 1.0 (process analysis) - Manual (Page 124)

3.6 Run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
112 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
NOTE
If a method is changed and saved in the method editor or during
reprocessing, then the latest method version will be loaded when a
new determination is started.
NOTE
The following sample data fields can no longer be edited if they were
defined as Fixed value in the method (see Chapter 5.5.2.2.2.4, page
385).
ID1
Sample identification ID1. Any text can be entered in this field. The type
and limit value check does not take place until the start of the determina-
tion. For sample identifications of the type Date/Time, the entry must be
formatted as YYYY-MM-DD or YYYY-MM-DD hh:mm:ss. Text tem-
plates may be selected if they are defined for sample identification (see
Chapter 3.5, page 106).
Entry 100 characters
Selection Selection of text templates
ID2
Sample identification ID2. Any text can be entered in this field. The type
and limit value check does not take place until the start of the determina-
tion. For sample identifications of the type Date/Time, the entry must be
formatted as YYYY-MM-DD or YYYY-MM-DD hh:mm:ss. Text tem-
plates may be selected if they are defined for sample identification (see
Chapter 3.5, page 106).
Entry 100 characters
Selection Selection of text templates
ID3
Sample identification ID3. Any text can be entered in this field. The type
and limit value check does not take place until the start of the determina-
tion. For sample identifications of the type Date/Time, the entry must be
formatted as YYYY-MM-DD or YYYY-MM-DD hh:mm:ss. Text tem-
plates may be selected if they are defined for sample identification (see
Chapter 3.5, page 106).
Entry 100 characters
Selection Selection of text templates