Metrohm viva 1.0 (process analysis) - Manual (Page 845)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 833
[Edit]
Opens the Properties - 'Controller type' dialog in order to edit the
selected controller (see Chapter 7.10.8.1, page 833).
[Delete]
Deletes the selected controller.
7.10.8.1 Properties - Controller type
Controller description
Freely selectable designation for the controller. This designation is used in
the program to actuate the controller.
Entry 1 - 50 characters
Default value Controller 1
The following characters must not be part of the
controller designation: \, ', ., {, }, [, ].
Controller behavior at
Action at power-on
Action which is to be executed when the device is switched on.
Selection Stop control | Continue control
Default value Stop control
Action at emergency stop
Action which is to be performed with an emergency stop.
Selection Stop control | Ignore emergency stop | Con-
tinue control
Default value Stop control
Action at control end
Action which is to be performed with the end of the control or when
there is an error.
Selection Keep values for outputs | Set default values
for outputs
Default value Keep values for outputs
[Details]
Opens the Details - 'Controller type' dialog in order to edit the selected
controller.