Metrohm viva 1.0 (process analysis) - Manual (Page 568)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
556 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
NOTE
If the not defined option is selected, then no ports can be selected in
the Digital outputs tab, because it is not known on which block this
instrument is referenced.
Even if a method is to be created independent of an instrument, an
instrument must still nevertheless be selected for the editing of the
block. One can however set the instrument name back to not defined
afterwards.
Device type
Display or selection of the instrument type. If an instrument is selected in
the Device name field, the Device type field can no longer be edited
and the instrument type belonging to the instrument is displayed.
If the not defined option is selected in the Device name field, all instru-
ment types or groups with which the command can be executed can be
selected, regardless of the instruments present in the device table.
Selection IO Controller | Stepping Motor Controller
Default value IO Controller
5.5.2.11.2.3 DIGITAL OUT - Digital outputs
Tab: Method ▶ DIGITAL OUT ▶ Properties... ▶ DIGITAL OUT - 'Command
name' ▶ Digital outputs
Command name
Name of the command.
Entry 25 characters
Table
The actuation of one digital output is parameterized in each line of the
Digital outputs table.
The Timer function is used with the Start delay and Working time
parameters in order to enable time-staggered parameterization.
One port can not be used more than once within a block.
If a command block originates from a different instrument, the Port
description of which does not exist on the currently selected instrument,
then the affected lines will be displayed in red lettering.