Metrohm viva 1.0 (process analysis) - Manual (Page 37)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 General program functions
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 25
Designation Description Commands
CYL Cylinder volume of the exchange or dosing unit used for the command ADD AUX,
ADD SAMPLE,
ADD SAMPLE
DT, ADD STD,
EMPTY, LQH,
PREP
DBL Total duration for the processing of the command in s CAL MEAS
Opt, CAL
Spec; CVS,
MEAS Opt,
MEAS Opt
Conc, MEAS
Ref, MEAS
Spec, MEAS
TMF
DEF Default value which is defined in the configuration for an IO port; 1 = active, 0 =
inactive ANALOG OUT,
DIGITAL OUT
ELT Variable for electrode test:
0 = Electrode test has not been performed
1 = Electrode test has been performed once
2 = Electrode test has been performed twice
3 = Electrode test has been performed three times
CVS
EME End measured value (measured value after processing of the command) in the
unit of the measured value CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
EPP Position after exiting the command: 0 = invalid position PORT
ETE End temperature (temperature following processing of the command) in °C CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
FIN Command status; 1 = Command has ended at least once, 0, invalid (variable
not available) = Command has never ended All except
START and
END
FP{x}.CNT Intensity for the fixed endpoint x (1 - 9) in counts MEAS Opt
FP{x}.MEA Measured value for the fixed endpoint x (1 - 9) in the unit of the measured value MEAS Opt
FP{x}.TEM Temperature for the fixed endpoint x (1 - 9) in °C MEAS Opt
FP{x}.TIM Time in s until the fixed endpoint x (1 - 9) is reached MEAS Opt
FP{x}.TRN Transmission for the fixed endpoint x (1 - 9) in % MEAS Opt