Metrohm viva 1.0 (process analysis) - Manual (Page 437)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 425
Command variables
The following command variables are generated by the MEAS Ref com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':
Identifi-
cation Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
DBL Total duration for the processing of the command in s
FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command has
never ended
STY Type of stop with which the command was stopped: 1 =
normal; 0 = manual or after error
5.5.2.5.2.2 MEAS Ref - General/Hardware
Tab: Method ▶ MEAS Ref ▶ Properties... ▶ MEAS Ref - 'Command name' ▶ Gen-
eral/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the instrument are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the instrument type. If an instrument is selected in
the Device name field, the Device type field can no longer be edited
and the instrument type belonging to the instrument is displayed.