Metrohm viva 1.0 (process analysis) - Manual (Page 576)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
564 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Table
One analog output is parameterized in each line of the Analog outputs
table. The calculated or fixed value is written directly to the selected ana-
log output during the run.
One port can not be used more than once within a command.
If a command originates from a different instrument, the Port descrip-
tion of which does not exist on the currently selected instrument, then
the affected lines will be displayed in red lettering.
Functions
Moves the selected line up.
Moves the selected line down.
[New]
Opens the Analog output # dialog window in order to edit a new line
(see Chapter 5.5.2.11.4.4, page 564).
[Properties]
Opens the Analog output # dialog window in order to edit the selected
line (see Chapter 5.5.2.11.4.4, page 564).
[Delete]
Deletes the selected line.
5.5.2.11.4.4 ANALOG OUT - Analog output #
Dialog window: Method ▶ ANALOG OUT ▶ Properties... ▶ ANALOG OUT - 'Com-
mand name' ▶ Analog outputs ▶ [Properties] ▶ ANALOG OUT - Analog output #
Port description
Selection of the analog output. The analog outputs of the selected instru-
ment are available. No port can be selected if not defined is selected in
the Device name field.
Type
Shows the analog output type.
Action
Selection Set value | Set default
Default value Set value
Set value
Writes the content of the Value field on the analog output.