Metrohm viva 1.0 (process analysis) - Manual (Page 652)

5.6 Evaluation subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
640 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Variable Description
Total volume (sample solution) in the measuring vessel at
the moment of the measurement of the VMS by calling
the measuring command via the command CALL VMS
at the moment of calibration.
Calibration factor DT. It corresponds to the concentra-
tion of the standard in the measuring vessel for the eval-
uation ratio.
5.6.7.7.21 Absolute standard deviation of the concentration of the suppres-
sor in the sample
Variable name RS.’Command name’.’Substance name’.CONC.ASD
Description Absolute standard deviation of the concentration of the suppressor in the
sample.
Decimal places 0 ... 2 ... 6
Unit As for concentration of the substance in the sample (see Chapter
5.6.7.6.1, page 629)
Remark Only for Calibration method = DT
5.6.7.7.22 Relative standard deviation of the concentration of the suppressor
in the sample
Variable name RS.’Command name’.’Substance name’.CONC.RSD
Description Relative standard deviation of the concentration of the suppressor in the
sample.
Decimal places 0…1…6
Unit %
Remark Only for Calibration method = DT.